policy routing with load balancing

From: Nodir Nazarov (nodir@xxxxxxxxxxxx)
Date: Fri Feb 02 2001 - 12:45:26 GMT-3

• Next message: Vikas Gupta: "DLSW questions"
• Previous message: Kelley, Richard A. (AIT): "RE: Dial Backup"
• Next in thread: Les Hardin: "Re: policy routing with load balancing"
• Maybe reply: Les Hardin: "Re: policy routing with load balancing"
• Maybe reply: Frank Liang: "Re: policy routing with load balancing"
• Maybe reply: Nodir Nazarov: "Re: policy routing with load balancing"
• Maybe reply: Frank Liang: "Re: policy routing with load balancing"
• Maybe reply: Nodir Nazarov: "Re: policy routing with load balancing"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hello, The Group !

How can I configure more than 1 "set interface" in route-maps for policy
routing so that outgoing traffic would be load balanced ? I did

route-map balance permit 110
 match ip address 171
 set interface Serial2/0/16:0 Serial2/0/17:0
!

But traffic matching ACL 171 goes only through first configured interface.
What is the purpose of having more than one interface statements in "set"?

Nodir

• Next message: Vikas Gupta: "DLSW questions"
• Previous message: Kelley, Richard A. (AIT): "RE: Dial Backup"
• Next in thread: Les Hardin: "Re: policy routing with load balancing"
• Maybe reply: Les Hardin: "Re: policy routing with load balancing"
• Maybe reply: Frank Liang: "Re: policy routing with load balancing"
• Maybe reply: Nodir Nazarov: "Re: policy routing with load balancing"
• Maybe reply: Frank Liang: "Re: policy routing with load balancing"
• Maybe reply: Nodir Nazarov: "Re: policy routing with load balancing"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:34 GMT-3