From: Frank Liang (liangfrank@xxxxxxxxxxx)
Date: Fri Feb 02 2001 - 17:18:51 GMT-3
If the first interface specified with the set interface command is down, the
optionally specified interfaces are tried in turn.
I understand that the second interface is used as backup, not load
balancing.
Frank
>From: Nodir Nazarov <nodir@datatone.com>
>Reply-To: Nodir Nazarov <nodir@datatone.com>
>To: ccielab@groupstudy.com
>Subject: policy routing with load balancing
>Date: Fri, 2 Feb 2001 10:45:26 -0500 (EST)
>
>Hello, The Group !
>
>How can I configure more than 1 "set interface" in route-maps for policy
>routing so that outgoing traffic would be load balanced ? I did
>
>route-map balance permit 110
> match ip address 171
> set interface Serial2/0/16:0 Serial2/0/17:0
>!
>
>But traffic matching ACL 171 goes only through first configured interface.
>What is the purpose of having more than one interface statements in "set"?
>
>Nodir
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:34 GMT-3