OSPF Problem

From: Moran, Ed (morane@xxxxxxxxxxxxxx)
Date: Mon Jan 22 2001 - 18:06:31 GMT-3

Next message: Padhu (LFG): "Troubleshooting - Lost IOS Image"
Previous message: Hebert, Cory J (cory.hebert@xxxxxxxx): "Catalyst Study"
Next in thread: Johnny Dedon: "Re: OSPF Problem"
Maybe reply: Johnny Dedon: "Re: OSPF Problem"
Maybe reply: Stanford Wong - SPAWAR: "RE: OSPF Problem"
Maybe reply: David FAHED: "Re: OSPF Problem"
Maybe reply: frank wells: "Re: OSPF Problem"
Maybe reply: Moran, Ed: "RE: OSPF Problem"
Maybe reply: Jimmy Dotson: "Re: OSPF Problem"
Maybe reply: Justin Menga: "RE: OSPF Problem"
Maybe reply: fwells12: "Re: OSPF Problem"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

I have OSPF configured over Frame Relay. I am using point-to-multipoint
explicitly. The neighbors are FULL, but I cannot ping between them. Any
ideas?

R5#sh ip ospf nei

Neighbor ID Pri State Dead Time Address Interface
138.1.3.3 1 FULL/ - 00:00:35 138.1.11.3 Serial0
R5#ping 138.1.3.3

Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 138.1.3.3, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5

E A Moran
Sr.Network Engineer/Project Manager
CNE,MCSE,CCNP,CCDP
TeleCommunication Systems
813-831-6353

Next message: Padhu (LFG): "Troubleshooting - Lost IOS Image"
Previous message: Hebert, Cory J (cory.hebert@xxxxxxxx): "Catalyst Study"
Next in thread: Johnny Dedon: "Re: OSPF Problem"
Maybe reply: Johnny Dedon: "Re: OSPF Problem"
Maybe reply: Stanford Wong - SPAWAR: "RE: OSPF Problem"
Maybe reply: David FAHED: "Re: OSPF Problem"
Maybe reply: frank wells: "Re: OSPF Problem"
Maybe reply: Moran, Ed: "RE: OSPF Problem"
Maybe reply: Jimmy Dotson: "Re: OSPF Problem"
Maybe reply: Justin Menga: "RE: OSPF Problem"
Maybe reply: fwells12: "Re: OSPF Problem"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:39 GMT-3