From: Jimmy Dotson (dotsonjl@xxxxxxx)
Date: Mon Jan 22 2001 - 19:20:20 GMT-3
Did you remember broadcast keyword on the frame map statements. This has gotte
n me a couple of times.
Jimmy
>>> "Moran, Ed" <morane@telecomsys.com> 01/22/01 04:06PM >>>
I have OSPF configured over Frame Relay. I am using point-to-multipoint
explicitly. The neighbors are FULL, but I cannot ping between them. Any
ideas?
R5#sh ip ospf nei
Neighbor ID Pri State Dead Time Address Interface
138.1.3.3 1 FULL/ - 00:00:35 138.1.11.3 Serial0
R5#ping 138.1.3.3
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 138.1.3.3, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5
E A Moran
Sr.Network Engineer/Project Manager
CNE,MCSE,CCNP,CCDP
TeleCommunication Systems
813-831-6353
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:39 GMT-3