From: Johnny Dedon (johnny.dedon@xxxxxxxxxx)
Date: Mon Jan 22 2001 - 18:35:10 GMT-3
Hi Ed,
On the frame config do you have map statements with the keyword broadcast?
Johnny Dedon
Senior Staff Consultant
Exodus Professional Services
johnny.dedon@exodus.net
www.exodus.net
----- Original Message -----
From: "Moran, Ed" <morane@telecomsys.com>
To: <ccielab@groupstudy.com>
Sent: Monday, January 22, 2001 3:06 PM
Subject: OSPF Problem
> I have OSPF configured over Frame Relay. I am using point-to-multipoint
> explicitly. The neighbors are FULL, but I cannot ping between them. Any
> ideas?
>
> R5#sh ip ospf nei
>
> Neighbor ID Pri State Dead Time Address
Interface
> 138.1.3.3 1 FULL/ - 00:00:35 138.1.11.3 Serial0
> R5#ping 138.1.3.3
>
> Type escape sequence to abort.
> Sending 5, 100-byte ICMP Echos to 138.1.3.3, timeout is 2 seconds:
> .....
> Success rate is 0 percent (0/5
>
> E A Moran
> Sr.Network Engineer/Project Manager
> CNE,MCSE,CCNP,CCDP
> TeleCommunication Systems
> 813-831-6353
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:39 GMT-3