From: Moran, Ed (morane@xxxxxxxxxxxxxx)
Date: Mon Jan 22 2001 - 18:48:05 GMT-3
-----Original Message-----
From: Stanford Wong - SPAWAR
To: Moran, Ed; ccielab@groupstudy.com
Sent: 1/22/01 4:37 PM
Subject: RE: OSPF Problem
Have you tried to ping the Neighbor's address as oppose to pinging the
router id? Unless the router id is being learned through the routing
process it will not be reachable.
post your config and do a show ip route....to see if the rid is being
learned through ospf.
stanford
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Moran, Ed
Sent: Monday, January 22, 2001 11:07 AM
To: 'ccielab@groupstudy.com'
Subject: OSPF Problem
I have OSPF configured over Frame Relay. I am using point-to-multipoint
explicitly. The neighbors are FULL, but I cannot ping between them. Any
ideas?
R5#sh ip ospf nei
Neighbor ID Pri State Dead Time Address
Interface
138.1.3.3 1 FULL/ - 00:00:35 138.1.11.3
Serial0
R5#ping 138.1.3.3
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 138.1.3.3, timeout is 2 seconds:
.....
Success rate is 0 percent (0/5
E A Moran
Sr.Network Engineer/Project Manager
CNE,MCSE,CCNP,CCDP
TeleCommunication Systems
813-831-6353
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:39 GMT-3