From: Daniel Ji (jix@xxxxxxxxxx)
Date: Wed Sep 20 2000 - 20:50:40 GMT-3
Hi:
Could anyone tell me what other thing I can try in order to bring my
token-ring interface up? I connected the TR interface with an RJ45 strait
cable to MAU(SMC Elite MAU 4016RN), but the interface is always in init
mode, and the port status light on the MAU was swithing between on and off
repeatedly. below is the screen output from router. please shed some light
on it.
----------------------------------------------------------------------------
-----------------------------------------------
TokenRing0 is initializing, line protocol is down
Hardware is TMS380, address is 0007.0dc6.df6d (bia 0007.0dc6.df6d)
MTU 4464 bytes, BW 4000 Kbit, DLY 2500 usec, rely 255/255, load 1/255
Encapsulation SNAP, loopback not set, keepalive set (10 sec)
ARP type: SNAP, ARP Timeout 04:00:00
Ring speed: 4 Mbps
Single ring node, Source Route Transparent Bridge capable
Group Address: 0x00000000, Functional Address: 0x08000000
Ethernet Transit OUI: 0x000000
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 166148 interface resets
0 output buffer failures, 0 output buffers swapped out
166153 transitions
----------------------------------------------------------------------------
-----------------------------------------------
Thanks a lot!
Daniel
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:59 GMT-3