US Robotic modem command !

From: Philip Lai (philip@xxxxxxxxxxx)
Date: Thu Jul 27 2000 - 11:18:28 GMT-3

• Next message: Michelle T: "Re: US Robotic modem command !"
• Previous message: Brian Hescock: "Re: Changing IPX RIP Hop Count"
• Next in thread: Michelle T: "Re: US Robotic modem command !"
• Maybe reply: Michelle T: "Re: US Robotic modem command !"
• Maybe reply: Robert LaGrasse: "Re: US Robotic modem command !"
• Maybe reply: Jason T. Rohm: "RE: US Robotic modem command !"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Hi, maybe it is sligthly out of the topic. Every time I reverse telnet to
the US Robotic modem and
type a "at&fs0=1" then "at&w". The modem is working correctly and can
receive incoming call.

However, if I switch off the modem and switch on again, all the setting in
the modem will lost. Thus, I have
to repeat the above procedure again.

Any body can give me some guideline from the "AT" command on how to store
the config in the modem and how to display them ?

Thanks.

Philip Lai

• Next message: Michelle T: "Re: US Robotic modem command !"
• Previous message: Brian Hescock: "Re: Changing IPX RIP Hop Count"
• Next in thread: Michelle T: "Re: US Robotic modem command !"
• Maybe reply: Michelle T: "Re: US Robotic modem command !"
• Maybe reply: Robert LaGrasse: "Re: US Robotic modem command !"
• Maybe reply: Jason T. Rohm: "RE: US Robotic modem command !"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:58 GMT-3