dot1x missing?

I know the trick that dot1x commands won't show up on an interface until
it's in access but am I missing something else here?
Port enabled
Dot1x enabled
port in access mode
dot1x configuration to port - FAIL

!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Cat3560-2(config)#do sho run | in dot
aaa authentication dot1x default group radius
dot1x system-auth-control
vlan dot1q tag native
Cat3560-2(config)#do sho run int gi0/6
Building configuration...

Current configuration : 110 bytes
!
interface GigabitEthernet0/6
  description R6 Fa0/0
  switchport access vlan 567
  switchport mode access
end

Cat3560-2(config)#int gi0/6
Cat3560-2(config-if)#dot1x port-control force-author
Cat3560-2(config-if)#do sho run int gi0/6
Building configuration...

Current configuration : 110 bytes
!
interface GigabitEthernet0/6
  description R6 Fa0/0
  switchport access vlan 567
  switchport mode access
end

Cat3560-2(config-if)#
Cat3560-2(config-if)#do sho dot1x
Sysauthcontrol = Enabled
Supplicant Allowed In Guest Vlan = Disabled
Dot1x Protocol Version = 1
Dot1x Oper Controlled Directions = Both
Dot1x Admin Controlled Directions = Both

Cat3560-2(config-if)#do sho dot1x all
No Dot1x Configuration exists
Cat3560-2(config-if)#
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

-- 
-Hammer-
"I was a normal American nerd"
-Jack Herer
Blogs and organic groups at http://www.ccie.net