Frame-relay config in GNS3

Hi,

All the time I configure frame-relay in GNS3, I couldn't filter the unwanted
DLCI coming from the FRSW.. Can anyone verify whether my config is wrong?

!
interface Serial1/0
 ip address 34.1.24.4 255.255.255.0
 encapsulation frame-relay
 serial restart-delay 0
 no dce-terminal-timing-enable
* no arp frame-relay*
 frame-relay map ip 34.1.24.2 402 broadcast
 frame-relay map ip 34.1.24.4 402
 frame-relay interface-dlci 402
* no frame-relay inverse-arp*
!
Rack1R4#show frame-relay map
Serial1/0 (up): ip 0.0.0.0 dlci 413(0x19D,0x64D0)
              broadcast,
              CISCO, status defined, active
Serial1/0 (up): ip 0.0.0.0 dlci 405(0x195,0x6450)
              broadcast,
              CISCO, status defined, active
Serial1/0 (up): ip 0.0.0.0 dlci 403(0x193,0x6430)
              broadcast,
              CISCO, status defined, active
Serial1/0 (up): ip 0.0.0.0 dlci 402(0x192,0x6420)
              broadcast,
              CISCO, status defined, active
Serial1/0 (up): ip 0.0.0.0 dlci 401(0x191,0x6410)
              broadcast,
              CISCO, status defined, active
Serial1/0 (up): ip 34.1.24.2 dlci 402(0x192,0x6420), static,
              broadcast,
              CISCO, status defined, active
Serial1/0 (up): ip 34.1.24.4 dlci 402(0x192,0x6420), static,
              CISCO, status defined, active
!
Rack1R4#show frame-relay pvc | include DLCI
DLCI = 401, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE = Serial1/0
DLCI = 402, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE = Serial1/0
DLCI = 403, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE = Serial1/0
DLCI = 405, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE = Serial1/0
DLCI = 413, DLCI USAGE = LOCAL, PVC STATUS = ACTIVE, INTERFACE = Serial1/0
!

I tried following actions, and result is negative

After configuring the interface shut the interface, and ensured no more
dynamic map & did no shut
Restarted the router

-- 
*Regards,*
*John*
Blogs and organic groups at http://www.ccie.net