Re: rsvp not working?

Do you have required mpls TE configuration on all intermediate
routers/interface (and ospf) between the source and destination?

On Fri, May 15, 2009 at 2:45 AM, ricky ong <rickyong2009_at_gmail.com> wrote:

> Hi, Just want to clear some concept issue here.. once i put "ip rsvp
> bandwidth" command under the interface, i should start to see some thing on
> rsvp debug? If two direct connected router both have "ip rsvp band"
> configured under their interface then i should see then as "rsvp neighbor
> using "show ip rsvp neighbor" command?
> I am still quite stuck at the RSVP problem now.. seems that opaque LSA
> is sending, with the "mpls trafic-eng router-id loopback0" and "mpls
> traffic-eng area 0" under OSPF..
> "mpls traffic-eng tunnel" and been configured on all routers globally and
> interface.. i dun think "mpls ip" is relevant to this issue since the TE
> label should be exchanged by RSVP, nevertheless, it is configured on all
> the
> router globally and interface.. but still.. i don't see any RSVP message on
> any of the routers.. can someone give me a clue? Thanks!
>
> Best Regards,
> Ricky
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>

-- 
Bryan Bartik
CCIE #23707 (R&S), CCNP
Sr. Support Engineer - IPexpert, Inc.
URL: http://www.IPexpert.com
Blogs and organic groups at http://www.ccie.net