From: Scott Morris (smorris@internetworkexpert.com)
Date: Thu Nov 27 2008 - 17:50:19 ARST
You could do passive for the interface (in router ospf config), or on the
interface itself you can use "no routing dynamic"
I'm not sure I'd consider either to be particularly "graceful" though.
:)
HTH,
Scott Morris, CCIE4 #4713, JNCIE-M #153, JNCIS-ER, CISSP, et al.
CCSI/JNCI-M/JNCI-ER
Senior CCIE Instructor
smorris@internetworkexpert.com
Knowledge is power.
Power corrupts.
Study hard and be Eeeeviiiil......
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
GAURAV MADAN
Sent: Thursday, November 27, 2008 1:11 PM
To: Cisco certification
Subject: Graceful shutdown : OSPF
Hi Group
I am aware of the fact that to gracefully bring down the core router running
OSPF ; we can use the "max-metric router-lsa ...." CLI ..
But on same time I read that "ip ospf shutdown" can be give at interface
level for same .
But somehow I dont find this in my routers .. Can someone confirm this :
R1(config-if)#int f0/0
R1(config-if)#ip ospf ?
<1-65535> Process ID
authentication Enable authentication
authentication-key Authentication password (key)
bfd Enable BFD on this interface
cost Interface cost
database-filter Filter OSPF LSA during synchronization and flooding
dead-interval Interval after which a neighbor is declared dead
demand-circuit OSPF demand circuit
flood-reduction OSPF Flood Reduction
hello-interval Time between HELLO packets
lls Link-local Signaling (LLS) support
message-digest-key Message digest authentication password (key)
mtu-ignore Ignores the MTU in DBD packets
network Network type
prefix-suppression OSPF prefix suppression
priority Router priority
resync-timeout Interval after which adjacency is reset if oob-resync
is
not started
retransmit-interval Time between retransmitting lost link state
advertisements
transmit-delay Link state transmit delay
Also I dont find following :
router ospf 10
shutdown
I read these from DOC cd as ways for graceful shutdown .. but couldnt find
present .. Plzz lemme know where I miss.
Thnx
Gaurav Madan
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Mon Dec 01 2008 - 08:18:32 ARST