From: Clay K Auch \(clauch\) (clauch@cisco.com)
Date: Wed Jul 25 2007 - 15:59:57 ART
Hello all,
I have not had much time to work with Dynamips, but the version of code I am running is shown in my show ver below. Is this the best/most recent version to run with Dynamips based on your experience?
========
Cisco IOS Software, 3600 Software (C3640-JS-M), Version 12.3(14)T7, RELEASE SOFTWARE (fc2)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2006 by Cisco Systems, Inc.
Compiled Wed 22-Mar-06 21:46 by pwade
ROM: ROMMON Emulation Microcode
ROM: 3600 Software (C3640-JS-M), Version 12.3(14)T7, RELEASE SOFTWARE (fc2)
L7R1 uptime is 0 minutes
System returned to ROM by unknown reload cause - suspect boot_data[BOOT_COUNT] 0x0, BOOT_COUNT 0, BOOTDATA 19
System image file is "tftp://255.255.255.255/unknown"
Cisco 3640 (R4700) processor (revision 0xFF) with 94208K/4096K bytes of memory.
Processor board ID 00000000
R4700 CPU at 100MHz, Implementation 33, Rev 1.2
1 FastEthernet interface
4 Serial interfaces
DRAM configuration is 64 bits wide with parity enabled.
125K bytes of NVRAM.
8192K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
========
Thank you much for your time,
Clay
This archive was generated by hypermail 2.1.4 : Sat Aug 18 2007 - 08:17:42 ART