From: Mounir Mohamed (mounir.mohamed@gmail.com)
Date: Wed Jul 25 2007 - 16:23:05 ART
Dear Ckay,
Sure no, you can use 12.4 or even 12.4T Code on Dynagen, but actually it's
depending on your feature needs.
On 7/25/07, Clay K Auch (clauch) <clauch@cisco.com> wrote:
>
> Hello all,
>
> I have not had much time to work with Dynamips, but the version of code I
> am running is shown in my show ver below. Is this the best/most recent
> version to run with Dynamips based on your experience?
>
> ========
>
> Cisco IOS Software, 3600 Software (C3640-JS-M), Version 12.3(14)T7,
> RELEASE SOFTWARE (fc2)
> Technical Support: http://www.cisco.com/techsupport
> Copyright (c) 1986-2006 by Cisco Systems, Inc.
> Compiled Wed 22-Mar-06 21:46 by pwade
>
> ROM: ROMMON Emulation Microcode
> ROM: 3600 Software (C3640-JS-M), Version 12.3(14)T7, RELEASE SOFTWARE
> (fc2)
>
> L7R1 uptime is 0 minutes
> System returned to ROM by unknown reload cause - suspect
> boot_data[BOOT_COUNT] 0x0, BOOT_COUNT 0, BOOTDATA 19
> System image file is "tftp://255.255.255.255/unknown"
>
> Cisco 3640 (R4700) processor (revision 0xFF) with 94208K/4096K bytes of
> memory.
> Processor board ID 00000000
> R4700 CPU at 100MHz, Implementation 33, Rev 1.2
> 1 FastEthernet interface
> 4 Serial interfaces
> DRAM configuration is 64 bits wide with parity enabled.
> 125K bytes of NVRAM.
> 8192K bytes of processor board System flash (Read/Write)
>
> Configuration register is 0x2102
>
> ========
>
> Thank you much for your time,
>
> Clay
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
-- Best Reagrds, Mounir Mohamed
This archive was generated by hypermail 2.1.4 : Sat Aug 18 2007 - 08:17:42 ART