From: srdja blagojevic (srdja1@pexim.co.yu)
Date: Sun Oct 15 2006 - 17:06:12 ART
Tee,
here is output from my 3560:
SW2(config)#int fa0/1
SW2(config-if)#serv
SW2(config-if)#service-policy ?
history Keep history of QoS metrics
input Assign policy-map to the input of an interface
output Assign policy-map to the output of an interface
my IOS image is: c3560-ipservices-mz.122-25.SEE1.bin
hth,
Srdja
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Simon Tee
Sent: Sunday, October 15, 2006 17:38
To: Cagri Yucel
Cc: ccielab@groupstudy.com
Subject: Re: 3560 output rate-limiting
Hi,
I do not have the error output from the switch, will try to obtain that and
post here, but if you lookup the command reference for 3560 there's only
"service-policy input".
Seems like only support it "one way"
regards,
Tee
On 10/15/06, Cagri Yucel <cyucel@gmail.com> wrote:
>
> What is the exact error you are getting ? This also might be due to
> some stuff you've put into policy-map.
>
> 3550 supports this happily, so if you can not even apply an empty
> policy-map a good step might be to check your IOS version ? Does it
> have IP support ? :)
>
>
> On 10/15/06, Simon Tee <teetengloong@gmail.com> wrote:
>
> > Hi guys,
> >
> > Wanted to enforce outgoing traffic bandwidth on a 3560 interface but
> > just realized that 3560 do not allow for the command "service-policy
> > output"
> > and
> > there's no rate-limit command available on the switch.
> >
> > Any idea how I can achieve this?
> >
> > Thanks and best regards,
> > Tee
> >
> > ____________________________________________________________________
> > ___ Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
> >
>
>
>
> --
> -cagri
This archive was generated by hypermail 2.1.4 : Wed Nov 01 2006 - 07:29:05 ART