From: Godswill Oletu (oletu@inbox.lv)
Date: Sun May 21 2006 - 22:25:05 ART
George,
No,Vlan10 will not show on sw2.
Since sw1 is in transparent mode, it will not share its vlan database info
with anyone, neither will it learn vlan information from anyone. If you have
some host(s) on vlan10 on sw2, you have to manually configure vlan10 on sw2
also.
HTH
Godswill Oletu
----- Original Message -----
From: "george stanza" <cert2006@gmail.com>
To: "Cisco certification" <ccielab@groupstudy.com>
Sent: Sunday, May 21, 2006 9:09 PM
Subject: VTP mode Transparent !!
> i have sw1 & sw2 both in transparent mode..but interfaces fa0/10 on both
the
> switches are connected thru ether-channel running PagP..and encap dot1q..
>
> Vlan 10 is configured on sw1 and 'switchport trunk allowed vlan 10' is
> configured on both the switchs 'ether-channel' mode..
>
> Wouldnt vlan 10 be shown on sw2 also ?..i dont see this happening..Both
> switches are running VTP version 2..
>
> sw1:
> ====
> interface FastEthernet0/10
> switchport trunk encapsulation dot1q
> switchport trunk allowed vlan 10
> switchport mode trunk
> channel-group 1 mode desirable
> !
> interface Port-channel1
> switchport trunk encapsulation dot1q
> switchport trunk allowed vlan 10
> switchport mode trunk
> !
>
> sw2:
> ===
> interface FastEthernet0/10
> switchport trunk encapsulation dot1q
> switchport trunk allowed vlan 10
> switchport mode trunk
> channel-group 1 mode desirable
> !
> interface Port-channel1
> switchport trunk encapsulation dot1q
> switchport trunk allowed vlan 10
> switchport mode trunk
> !
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Thu Jun 01 2006 - 06:33:22 ART