From: Nick Griffin (ngriffin@sio.midco.net)
Date: Sun May 21 2006 - 22:22:53 ART
You set the vtp mode to transparent, so vtp adv won't be sent. You'll
need to configure the vlan on both switches manually.
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat5000/rel_6_1/quick_sw/vlans.htm#1015125
george stanza wrote:
> i have sw1 & sw2 both in transparent mode..but interfaces fa0/10 on both the
> switches are connected thru ether-channel running PagP..and encap dot1q..
>
> Vlan 10 is configured on sw1 and 'switchport trunk allowed vlan 10' is
> configured on both the switchs 'ether-channel' mode..
>
> Wouldnt vlan 10 be shown on sw2 also ?..i dont see this happening..Both
> switches are running VTP version 2..
>
> sw1:
> ====
> interface FastEthernet0/10
> switchport trunk encapsulation dot1q
> switchport trunk allowed vlan 10
> switchport mode trunk
> channel-group 1 mode desirable
> !
> interface Port-channel1
> switchport trunk encapsulation dot1q
> switchport trunk allowed vlan 10
> switchport mode trunk
> !
>
> sw2:
> ===
> interface FastEthernet0/10
> switchport trunk encapsulation dot1q
> switchport trunk allowed vlan 10
> switchport mode trunk
> channel-group 1 mode desirable
> !
> interface Port-channel1
> switchport trunk encapsulation dot1q
> switchport trunk allowed vlan 10
> switchport mode trunk
> !
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Thu Jun 01 2006 - 06:33:22 ART