From: b1t AvAtAr (b1t.avatar@gmail.com)
Date: Tue Apr 04 2006 - 13:16:03 GMT-3
Hi Guys, please could anyone support me on this One, Which IOS Image should
I use to support IPV6 in this 2522 Router
FRS-BB2#conf te
Enter configuration commands, one per line. End with CNTL/Z.
FRS-BB2(config)#interface Loopback0
FRS-BB2(config-if)# ip address 220.20.3.1 255.255.255.0
FRS-BB2(config-if)# ipv6 address 2001:220:20:3::1/64
^
% Invalid input detected at '^' marker.
FRS-BB2(config-if)# ipv6 rip RIPng enable
^
% Invalid input detected at '^' marker.
FRS-BB2(config-if)#!
FRS-BB2(config-if)#interface Loopback1
FRS-BB2(config-if)# ip address 222.22.2.1 255.255.255.0
FRS-BB2(config-if)# ipv6 address 2001:222:22:2::1/64
^
% Invalid input detected at '^' marker.
FRS-BB2(config-if)# ipv6 rip RIPng enable
^
% Invalid input detected at '^' marker.
FRS-BB2(config-if)#!
FRS-BB2(config-if)#interface Loopback3
FRS-BB2(config-if)# ip address 205.90.31.1 255.255.255.0
FRS-BB2(config-if)# ipv6 address 2001:205:90:31::1/64
^
% Invalid input detected at '^' marker.
FRS-BB2(config-if)# ipv6 rip RIPng enable
^
% Invalid input detected at '^' marker.
FRS-BB2(config-if)#!
FRS-BB2(config-if)#interface Loopback51515151
FRS-BB2(config-if)# ip address 51.51.51.51 255.255.255.255
FRS-BB2(config-if)# ipv6 address 2001:51:51:51::51/64
^
% Invalid input detected at '^' marker.
FRS-BB2(config-if)#
FRS-BB2(config-if)#do show ver
^
% Invalid input detected at '^' marker.
FRS-BB2(config-if)#^Z
FRS-BB2#show ver
Cisco Internetwork Operating System Software
IOS (tm) 2500 Software (C2500-JS-L), Version 12.2(27), RELEASE SOFTWARE
(fc3)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Tue 02-Nov-04 22:01 by kellmill
Image text-base: 0x0307D390, data-base: 0x00001000
ROM: System Bootstrap, Version 11.0(10c), SOFTWARE
BOOTLDR: 3000 Bootstrap Software (IGS-BOOT-R), Version 11.0(10c), RELEASE
SOFTWARE (fc1)
FRS-BB2 uptime is 5 days, 14 hours, 35 minutes
System returned to ROM by reload
System image file is "flash:/c2500-js-l.122-27.bin"
cisco 2522 (68030) processor (revision M) with 14336K/2048K bytes of memory.
Processor board ID 14512161, with hardware revision 00000003
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
Basic Rate ISDN software, Version 1.1.
1 Ethernet/IEEE 802.3 interface(s)
2 Serial network interface(s)
8 Low-speed serial(sync/async) network interface(s)
1 ISDN Basic Rate interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read ONLY)
Configuration register is 0x2102
This archive was generated by hypermail 2.1.4 : Mon May 01 2006 - 11:41:56 GMT-3