From: Scott Morris (swm@emanon.com)
Date: Tue Nov 08 2005 - 11:02:28 GMT-3
Reflector-port is a parameter specified on the source-side of the Remote
spanning session. It's not a vlan-oriented command.
HTH,
Scott
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Mike
Flanagan
Sent: Tuesday, November 08, 2005 8:57 AM
To: Cisco certification
Subject: Trouble configuring RSPAN
Looking at the doc cd when configuring RSPAN you are to use the
reflector-port command. I am not seeing this as an option on my switch. Is
this needed to make this work? I just added the remote- vlan <VLAN> instead
since that is the only option I had. I am running 12.1(19)EA1d
Thanks,
http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12225sec/
3550scg/swspan.htm
SW1#conf t
Enter configuration commands, one per line. End with CNTL/Z.
SW1(config)#vlan 101
SW1(config-vlan)#remo
SW1(config-vlan)#remote-span
SW1(config-vlan)#end
SW1#
SW1(config)#monitor session 1 source interface gigabitEthernet 1/0/1
both
SW1(config)#monitor session 1 destination remote vlan 101 ?
<cr>
SW1(config)#$sion 1 destination remote vlan 101 reflector-port
gig1/0/10
monitor session 1 destination remote vlan 101 reflector-port gig1/0/10
^
This archive was generated by hypermail 2.1.4 : Thu Dec 01 2005 - 09:12:05 GMT-3