From: Mike Flanagan (mikenoc@mindspring.com)
Date: Tue Nov 08 2005 - 10:56:48 GMT-3
Looking at the doc cd when configuring RSPAN you are to use the
reflector-port command. I am not seeing this as an option on my
switch. Is this needed to make this work? I just added the remote-
vlan <VLAN> instead since that is the only option I had. I am running
12.1(19)EA1d
Thanks,
http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12225sec/
3550scg/swspan.htm
SW1#conf t
Enter configuration commands, one per line. End with CNTL/Z.
SW1(config)#vlan 101
SW1(config-vlan)#remo
SW1(config-vlan)#remote-span
SW1(config-vlan)#end
SW1#
SW1(config)#monitor session 1 source interface gigabitEthernet 1/0/1
both
SW1(config)#monitor session 1 destination remote vlan 101 ?
<cr>
SW1(config)#$sion 1 destination remote vlan 101 reflector-port
gig1/0/10
monitor session 1 destination remote vlan 101 reflector-port gig1/0/10
^
This archive was generated by hypermail 2.1.4 : Thu Dec 01 2005 - 09:12:05 GMT-3