From: Mike Flanagan (mikenoc@mindspring.com)
Date: Tue Nov 08 2005 - 11:40:29 GMT-3
SW1 is the has the source port that I want SW2 to be able to view
traffic from. The source port is 1/0/1. I am definitely confused on
the reflector port. What I want to so is monitor traffic from port
1/0/1 to a port on sw2. From reading what the reflector port does it
"SPAN traffic from the sources is copied onto the RSPAN VLAN through
a reflector port and then forwarded over trunk ports that are
carrying the RSPAN VLAN to any RSPAN destination sessions monitoring
the RSPAN VLAN" So I think I need to add the reflector port command
using the same interface 1/0/1 instead of 1/0/10. But the problem is
the switch is not allowing me to add the reflector port command. So
I am sure I am missing something just do not know what it is.
Thanks,
Mike F.
On Nov 8, 2005, at 9:02 AM, Scott Morris wrote:
> Reflector-port is a parameter specified on the source-side of the
> Remote
> spanning session. It's not a vlan-oriented command.
>
> HTH,
>
> Scott
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On
> Behalf Of Mike
> Flanagan
> Sent: Tuesday, November 08, 2005 8:57 AM
> To: Cisco certification
> Subject: Trouble configuring RSPAN
>
> Looking at the doc cd when configuring RSPAN you are to use the
> reflector-port command. I am not seeing this as an option on my
> switch. Is
> this needed to make this work? I just added the remote- vlan <VLAN>
> instead
> since that is the only option I had. I am running 12.1(19)EA1d
>
>
> Thanks,
>
> http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12225sec/
> 3550scg/swspan.htm
>
>
> SW1#conf t
> Enter configuration commands, one per line. End with CNTL/Z.
> SW1(config)#vlan 101
> SW1(config-vlan)#remo
> SW1(config-vlan)#remote-span
> SW1(config-vlan)#end
> SW1#
>
> SW1(config)#monitor session 1 source interface gigabitEthernet 1/0/1
> both
> SW1(config)#monitor session 1 destination remote vlan 101 ?
> <cr>
>
> SW1(config)#$sion 1 destination remote vlan 101 reflector-port
> gig1/0/10
> monitor session 1 destination remote vlan 101 reflector-port
> gig1/0/10
> ^
>
> ______________________________________________________________________
> _
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> ______________________________________________________________________
> _
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Thu Dec 01 2005 - 09:12:05 GMT-3