From: Brian McGahan (bmcgahan@internetworkexpert.com)
Date: Tue Aug 02 2005 - 12:14:35 GMT-3
Have you tested it? Post your results from "debug dialer" on both ends.
Brian McGahan, CCIE #8593
bmcgahan@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987 x 705
Outside US: 775-826-4344 x 705
24/7 Support: http://forum.internetworkexpert.com
Live Chat: http://www.internetworkexpert.com/chat/
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
Of
> kumara.shunmugam@wipro.com
> Sent: Tuesday, August 02, 2005 4:52 AM
> To: ccielab@groupstudy.com
> Subject: IEWB Lab 13-Q-4.6 (ISDN)
>
> Dear All
>
> This scenario is using a dialer interface to call the remote end. The
> requirement is to do a call screening based on the specified incoming
> number
> pattern (527XXXX) and initiate a callback to R5. The answer is to use
the
> "dialer caller 527XXXX callback". Can we not use the old legacy
command
> "isdn
> caller 527XXXX callback" for the same in the physical BRI interface.
> Cisco
> Says to use Dialer Caller for Dialer interface... But logically the
other
> command also should work...Can any one throw the exact differences
between
> these two ?
>
> Regards
> Shunmugam
>
>
>
>
>
> Confidentiality Notice
>
> The information contained in this electronic message and any
attachments
> to
> this message are intended
> for the exclusive use of the addressee(s) and may contain confidential
or
> privileged information. If
> you are not the intended recipient, please notify the sender at Wipro
or
> Mailadmin@wipro.com immediately
> and destroy all copies of this message and any attachments.
>
>
This archive was generated by hypermail 2.1.4 : Sun Sep 04 2005 - 17:01:18 GMT-3