From: kumara.shunmugam@wipro.com
Date: Tue Aug 02 2005 - 06:51:57 GMT-3
Dear All
This scenario is using a dialer interface to call the remote end. The
requirement is to do a call screening based on the specified incoming number
pattern (527XXXX) and initiate a callback to R5. The answer is to use the
"dialer caller 527XXXX callback". Can we not use the old legacy command "isdn
caller 527XXXX callback" for the same in the physical BRI interface. Cisco
Says to use Dialer Caller for Dialer interface... But logically the other
command also should work...Can any one throw the exact differences between
these two ?
Regards
Shunmugam
Confidentiality Notice
The information contained in this electronic message and any attachments to
this message are intended
for the exclusive use of the addressee(s) and may contain confidential or
privileged information. If
you are not the intended recipient, please notify the sender at Wipro or
Mailadmin@wipro.com immediately
and destroy all copies of this message and any attachments.
This archive was generated by hypermail 2.1.4 : Sun Sep 04 2005 - 17:01:18 GMT-3