From: SIMON HART (simon.hart@btinternet.com)
Date: Fri May 20 2005 - 07:37:58 GMT-3
This may seem like a fairly trivial question, but I have not seen this before, any help?
I have configured a Legacy DDR using Basic Net-3 on an ISDN BRI0
int bri0
isdn switch-type basic-net3
ip address 172.1.1.2 255.255.255.0
dialer map ip 172.1.1.1 name Rack1R3 720451
dialer-group 1
dialer-list 1 permit protocol ip
Whenever I initiate a call from this interface both ISDN B channels come up. There are no dialer load threshold statements etc. I can see both lines coming up on the local and remote routers. I have connectivity with both ends (so I am not dialing back on myself).
Why is this the case? How do I stop it? I am sure that this is not normal behaviour
Thanks
Simon
This archive was generated by hypermail 2.1.4 : Fri Jun 03 2005 - 10:11:59 GMT-3