Re: ISDN Basic-Net 3

From: Hinet--林榮毅 (easyman.lin@msa.hinet.net)
Date: Fri May 20 2005 - 13:34:29 GMT-3

I guess you must forget the line "encapsulation ppp"
if you forgot you will have "hdlc" encapsulation with your bri interface , and it will cause the two routers maintain 2 separate B channel .
as Scott mentioned ~~~

----- Original Message -----
From: "Scott Morris" <swm@emanon.com>
To: "'SIMON HART'" <simon.hart@btinternet.com>; <ccielab@groupstudy.com>
Sent: 2005e945f20f% d8 e 08:58
Subject: RE: ISDN Basic-Net 3

> It depends on what the other side configuration is.... But I'd be willing
> to bet you are ending up with two UNIdirectional links. Do a 'debug isdn
> q931' and 'debug ip packet' on the other side. You will likely see the
> first line go up, the first packet come in, and as it tries to send out the
> reply packet it will place another phone call (not realizing it's already
> connected).
>
> This has nothing to do with the isdn switch-type per se. It has to do with
> incoming call information (show dialer as an example) and whether the router
> believes it's already connected or it has to dial out to send the reply (per
> the dialer map). It's simply a L3 to L2 mapping correlation issue.
>
> HTH,
>
> Scott
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> SIMON HART
> Sent: Friday, May 20, 2005 6:38 AM
> To: ccielab@groupstudy.com
> Subject: ISDN Basic-Net 3
>
> This may seem like a fairly trivial question, but I have not seen this
> before, any help?
>
> I have configured a Legacy DDR using Basic Net-3 on an ISDN BRI0
>
> int bri0
> isdn switch-type basic-net3
> ip address 172.1.1.2 255.255.255.0
> dialer map ip 172.1.1.1 name Rack1R3 720451 dialer-group 1
>
> dialer-list 1 permit protocol ip
>
> Whenever I initiate a call from this interface both ISDN B channels come up.
> There are no dialer load threshold statements etc. I can see both lines
> coming up on the local and remote routers. I have connectivity with both
> ends (so I am not dialing back on myself).
>
> Why is this the case? How do I stop it? I am sure that this is not normal
> behaviour
>
> Thanks
>
> Simon
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

This archive was generated by hypermail 2.1.4 : Fri Jun 03 2005 - 10:11:59 GMT-3