From: marvin greenlee (marvin@ccbootcamp.com)
Date: Wed Nov 10 2004 - 23:12:15 GMT-3
The Switch will automatically add the port.
Cat1(config)#aaa new
Cat1(config)#radius-server host 1.2.3.4
Cat1(config)#end
Cat1#show run | include radius
radius-server host 1.2.3.4 auth-port 1812 acct-port 1813
radius-server retransmit 3
Cat1#
- Marvin Greenlee, CCIE#12237
Network Learning Inc
marvin@ccbootcamp.com
www.ccbootcamp.com (Cisco Training)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of John
Matus
Sent: Wednesday, November 10, 2004 5:59 PM
To: lab
Subject: cisco press lab 1.dox1x/radius [bcc][faked-from]
Importance: Low
the requirement...authorizing a port via radius.
the solution has : radius-server host 1.2.3.4 auth-port 1812 key radius-key
....what is the purpose of using port 1812? the requirements did not
specify
to use this port so i'm wonding if i'm missing some subtle nuance of the
task.
Regards,
John D. Matus
MCSE, CCNP
Office: 818-782-2061
Cell: 818-430-8372
jmatus@pacbell.net
This archive was generated by hypermail 2.1.4 : Thu Dec 02 2004 - 06:57:41 GMT-3