From: marc van hoof (mvh@marcvanhoof.com)
Date: Wed Nov 10 2004 - 23:22:12 GMT-3
it comes down to whether you want to use the new radius ports 1812/1813 or
the old radius ports 1645/1646...
i'm guessing that the task was trying to make sure that you knew that 1812
is authorization/authentication and 1813 is accounting.
-marc.
On Wed, 10 Nov 2004, marvin greenlee wrote:
> The Switch will automatically add the port.
>
>
> Cat1(config)#aaa new
> Cat1(config)#radius-server host 1.2.3.4
> Cat1(config)#end
> Cat1#show run | include radius
> radius-server host 1.2.3.4 auth-port 1812 acct-port 1813
> radius-server retransmit 3
> Cat1#
>
>
>
>
> - Marvin Greenlee, CCIE#12237
> Network Learning Inc
> marvin@ccbootcamp.com
> www.ccbootcamp.com (Cisco Training)
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of John
> Matus
> Sent: Wednesday, November 10, 2004 5:59 PM
> To: lab
> Subject: cisco press lab 1.dox1x/radius [bcc][faked-from]
> Importance: Low
>
> the requirement...authorizing a port via radius.
> the solution has : radius-server host 1.2.3.4 auth-port 1812 key radius-key
>
> ....what is the purpose of using port 1812? the requirements did not
> specify
> to use this port so i'm wonding if i'm missing some subtle nuance of the
> task.
>
>
> Regards,
>
> John D. Matus
> MCSE, CCNP
> Office: 818-782-2061
> Cell: 818-430-8372
> jmatus@pacbell.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Thu Dec 02 2004 - 06:57:41 GMT-3