From: Ahmed Mustafa (ahmed.mustafa@sbcglobal.net)
Date: Wed Feb 25 2004 - 22:44:46 GMT-3
I tried with the metric option, but didn't work either. The reason I didn't
think about metric because I am able to redisribute the ethernet interfaces
w/o any problems, it is just the loopback that is giving me a grief.
----- Original Message -----
From: "Bob Sinclair" <bsinclair@netmasterclass.net>
To: "Ahmed Mustafa" <ahmed.mustafa@sbcglobal.net>; <ccielab@groupstudy.com>
Sent: Wednesday, February 25, 2004 4:12 PM
Subject: Re: redistribute Loopbacks
> Ahmed,
>
> I believe that when redistributing INTO ISIS you need to add a metric
> between 1 and 63 on the redistribute command. . By default it comes in
with
> metric 0 and acts like RIP or EGRP.
>
> Bob Sinclair
> CCIE #10427, CISSP, MCSE
> www.netmasterclass.net
>
> ----- Original Message -----
> From: "Ahmed Mustafa" <ahmed.mustafa@sbcglobal.net>
> To: <ccielab@groupstudy.com>
> Sent: Wednesday, February 25, 2004 7:01 PM
> Subject: redistribute Loopbacks
>
>
> > Is there anything other than simply use the following commands.
> >
> > R1 and R6 are connected via ISIS Level-1 only.
> >
> > on R6, I have a loopback interface 6 configured with 132.1.6.0/24, and I
> > redistributed via redistributed connected method.
> >
> > r6
> >
> > router isis
> > redistributed connected route-map connected2isis
> >
> >
> > route-map connected2isis permit 10
> > match interface loopback 6
> >
> > But the route will not appear on R1.
> >
> > Any advise !
> >
> > Regards,
> >
> > Ahmed
> >
> > _______________________________________________________________________
> > Please help support GroupStudy by purchasing your study materials from:
> > http://shop.groupstudy.com
> >
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Mar 05 2004 - 07:13:57 GMT-3