From: Brian Dennis (brian@labforge.com)
Date: Sun Jun 15 2003 - 01:45:38 GMT-3
Are you sure that you have the port setup as a routed port first?
Rack6SW1(config-if)#int fa0/1
Rack6SW1(config-if)#switchport
Rack6SW1(config-if)#ip pim ?
% Unrecognized command
Rack6SW1(config-if)#no switchport
Rack6SW1(config-if)#ip pim ?
bsr-border Border of PIM domain
dense-mode Enable PIM dense-mode operation
nbma-mode Use Non-Broadcast Multi-Access (NBMA) mode on
interface
neighbor-filter PIM peering filter
query-interval PIM router query interval
sparse-dense-mode Enable PIM sparse-dense-mode operation
sparse-mode Enable PIM sparse-mode operation
version PIM version
<cr>
Brian Dennis, CCIE #2210 (R&S/ISP-Dial/Security)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Emad
Sent: Saturday, June 14, 2003 12:42 PM
To: ccielab@groupstudy.com
Subject: CAT3550 : multicast problem
Folks,
I was doing multicast scenario and I enabled multicast routing globally
but I
didn't find the multicast commands like IP pim or cgmp under the
physical
interfaces and I found them under the vlan interfaces only
this is the info of my switch
sh ver
Cisco Internetwork Operating System Software
IOS (tm) C3550 Software (C3550-I5Q3L2-M), Version 12.1(12c)EA1, RELEASE
SOFTWARE (fc1)
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Mon 25-Nov-02 00:07 by antonino
Image text-base: 0x00003000, data-base: 0x0075FE48
ROM: Bootstrap program is C3550 boot loader
Down-Backbone uptime is 5 hours, 14 minutes
System returned to ROM by power-on
System image file is
"flash:c3550-i5q3l2-mz.121-12c.EA1/c3550-i5q3l2-mz.121-12c.EA1.bin"
cisco WS-C3550-24 (PowerPC) processor (revision H0) with 65526K/8192K
bytes of
memory.
Processor board ID CAT0706Y0R9
Last reset from warm-reset
Bridging software.
Running Layer2/3 Switching Image
Ethernet-controller 1 has 12 Fast Ethernet/IEEE 802.3 interfaces
Plz advise
This archive was generated by hypermail 2.1.4 : Fri Jul 04 2003 - 11:10:58 GMT-3