From: wing_lam@jossynergy.com
Date: Sun Jun 15 2003 - 03:12:42 GMT-3
Hi, Emad,
Does the port you running in route mode or switch mode? "ip pim" commands
can only be found on route mode. You can find it in VLAN interface as it
must be routed for VLAN interface. You can activate route mode in a port by
"no switchport" interface configuration command.
Thx,
BBD (Big Black Dog)
"Emad"
<emad@zakq8.com> To: <ccielab@groupstudy.com>
Sent by: cc:
nobody@groupstudy Subject: CAT3550 : multicast problem
.com
06/15/2003 03:41
AM
Please respond to
"Emad"
Folks,
I was doing multicast scenario and I enabled multicast routing globally but
I
didn't find the multicast commands like IP pim or cgmp under the physical
interfaces and I found them under the vlan interfaces only
this is the info of my switch
sh ver
Cisco Internetwork Operating System Software
IOS (tm) C3550 Software (C3550-I5Q3L2-M), Version 12.1(12c)EA1, RELEASE
SOFTWARE (fc1)
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Mon 25-Nov-02 00:07 by antonino
Image text-base: 0x00003000, data-base: 0x0075FE48
ROM: Bootstrap program is C3550 boot loader
Down-Backbone uptime is 5 hours, 14 minutes
System returned to ROM by power-on
System image file is
"flash:c3550-i5q3l2-mz.121-12c.EA1/c3550-i5q3l2-mz.121-12c.EA1.bin"
cisco WS-C3550-24 (PowerPC) processor (revision H0) with 65526K/8192K bytes
of
memory.
Processor board ID CAT0706Y0R9
Last reset from warm-reset
Bridging software.
Running Layer2/3 Switching Image
Ethernet-controller 1 has 12 Fast Ethernet/IEEE 802.3 interfaces
Plz advise
This archive was generated by hypermail 2.1.4 : Fri Jul 04 2003 - 11:10:58 GMT-3