PIM question

From: Emad (emad@zakq8.com)
Date: Fri Jun 06 2003 - 11:56:20 GMT-3

• Next message: Tim Fletcher: "Re: Question about Cisco routers"
• Previous message: John Matijevic: "Re: ip gdp irdp?"
• Next in thread: James.Jackson@broadwing.com: "RE: PIM question"
• Maybe reply: James.Jackson@broadwing.com: "RE: PIM question"
• Maybe reply: Emad: "RE: PIM question"
• Maybe reply: boby2kusa: "Re: PIM question"
• Maybe reply: Emad: "RE: PIM question"
• Maybe reply: dredeze: "RE: PIM question"
• Maybe reply: Emad: "RE: PIM question"
• Maybe reply: Daniel Cisco Group Study: "RE: PIM question"
• Maybe reply: wing_lam@jossynergy.com: "RE: PIM question"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Folks,
When I configure PIM protocol under FR multipoint interface , is there any specific command that should be combined with IP PIM dense or sparse mode to work under Multipoint interface ,( of course beside IGM join-group command)

Regards

• Next message: Tim Fletcher: "Re: Question about Cisco routers"
• Previous message: John Matijevic: "Re: ip gdp irdp?"
• Next in thread: James.Jackson@broadwing.com: "RE: PIM question"
• Maybe reply: James.Jackson@broadwing.com: "RE: PIM question"
• Maybe reply: Emad: "RE: PIM question"
• Maybe reply: boby2kusa: "Re: PIM question"
• Maybe reply: Emad: "RE: PIM question"
• Maybe reply: dredeze: "RE: PIM question"
• Maybe reply: Emad: "RE: PIM question"
• Maybe reply: Daniel Cisco Group Study: "RE: PIM question"
• Maybe reply: wing_lam@jossynergy.com: "RE: PIM question"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Jul 04 2003 - 11:10:53 GMT-3