From: Emad (emad@zakq8.com)
Date: Fri Jun 06 2003 - 14:40:54 GMT-3
I just heard about IP pim nbma-mode command if multicast is enabled under multipoint interfaces , is it must?
-----Original Message-----
From: boby2kusa [mailto:boby2kusa@hotmail.com]
Sent: Friday, June 06, 2003 8:01 PM
To: Emad; CCIE LAB (E-mail)
Subject: Re: PIM question
When you configure PIM dense-mode, or pim sparse-mode or pim
sparse-dense-mode. you're basically telling that router to listen and
participate in multicasting either by listening to a join by a client, an
announcement of multicast group from a streamer or another multicast router
in case of the sparse mode. The igmp join-group is a configuration to
ensure that that interface is always passing multicast traffic. What are
you looking for when you ask what other combo is needed with pim
configurations?
----- Original Message -----
From: "Emad" <emad@zakq8.com>
To: "CCIE LAB (E-mail)" <ccielab@groupstudy.com>
Sent: Friday, June 06, 2003 7:56 AM
Subject: PIM question
> Folks,
> When I configure PIM protocol under FR multipoint interface , is there
any specific command that should be combined with IP PIM dense or sparse
mode to work under Multipoint interface ,( of course beside IGM join-group
command)
>
> Regards
This archive was generated by hypermail 2.1.4 : Fri Jul 04 2003 - 11:10:54 GMT-3