From: Emad (emad@zakq8.com)
Date: Fri Jun 06 2003 - 14:06:14 GMT-3
Yes I mean it , but I found a lot of examples in popular books like Karl Solie book not using this command under multipoint interfaces , is it necessary under all multipoint interface to multicast to work well !!!!
-----Original Message-----
From: James.Jackson@broadwing.com [mailto:James.Jackson@broadwing.com]
Sent: Friday, June 06, 2003 7:40 PM
To: Emad; ccielab@groupstudy.com
Subject: RE: PIM question
ip pim nbma-mode ?
-----Original Message-----
From: Emad [mailto:emad@zakq8.com]
Sent: Friday, June 06, 2003 9:56 AM
To: CCIE LAB (E-mail)
Subject: PIM question
Folks,
When I configure PIM protocol under FR multipoint interface , is there any
specific command that should be combined with IP PIM dense or sparse mode
to work under Multipoint interface ,( of course beside IGM join-group
command)
Regards
+++The information transmitted is intended only for the person or entity to
which it is addressed and may contain confidential and/or privileged
material. Any review, retransmission, dissemination or other use of, or
taking of any action in reliance upon, this information by persons or
entities other than the intended recipient is prohibited. If you received
this in error, please contact the sender and destroy any copies of this
document.+++
This archive was generated by hypermail 2.1.4 : Fri Jul 04 2003 - 11:10:53 GMT-3