From: wing_lam@jossynergy.com
Date: Sat Jun 07 2003 - 03:31:11 GMT-3
Hi Emad,
There will be problem for multi-point interface work with dense mode, as
some spoke sites leave message won't be seen by other spoke site, then hub
site would delete the group when any spoke site member leaves (coz othe
members doesn't hear about the leave so that to override it according to
dense mode). Because of this the command "ip pim nbma-mode" is configured
so that each subscribed spoke site client will have an entry in the hub
site (IP address under the "show ip mroute") so that even one of spoke site
leaves, the hub iste won't regard there is no active members as other spoke
sites IP address still under the mroute entry.
Rgds,
BBD (Big Black Dog)
"Emad"
<emad@zakq8.com> To: <James.Jackson@broadwing.com>, <ccielab@groupstudy.com>
Sent by: cc:
nobody@groupstudy Subject: RE: PIM question
.com
06/07/2003 01:06
AM
Please respond to
"Emad"
Yes I mean it , but I found a lot of examples in popular books like Karl
Solie book not using this command under multipoint interfaces , is it
necessary under all multipoint interface to multicast to work well !!!!
-----Original Message-----
From: James.Jackson@broadwing.com [mailto:James.Jackson@broadwing.com]
Sent: Friday, June 06, 2003 7:40 PM
To: Emad; ccielab@groupstudy.com
Subject: RE: PIM question
ip pim nbma-mode ?
-----Original Message-----
From: Emad [mailto:emad@zakq8.com]
Sent: Friday, June 06, 2003 9:56 AM
To: CCIE LAB (E-mail)
Subject: PIM question
Folks,
When I configure PIM protocol under FR multipoint interface , is there any
specific command that should be combined with IP PIM dense or sparse mode
to work under Multipoint interface ,( of course beside IGM join-group
command)
Regards
+++The information transmitted is intended only for the person or entity
to
which it is addressed and may contain confidential and/or privileged
material. Any review, retransmission, dissemination or other use of, or
taking of any action in reliance upon, this information by persons or
entities other than the intended recipient is prohibited. If you received
this in error, please contact the sender and destroy any copies of this
document.+++
This archive was generated by hypermail 2.1.4 : Fri Jul 04 2003 - 11:10:54 GMT-3