From: Jay Hennigan (jay@west.net)
Date: Sun Apr 20 2003 - 22:54:04 GMT-3
On Mon, 21 Apr 2003, Tarun Pahuja wrote:
> Folks, Is there a show command which can show how policy based routing is
> defined on an interface? I used the following commands but never got any
> output after configuring PBR on an interface. How do i know PBR is
> working? show policy-map aaashow interface interface eth 0 They both gave
> be no results. Here is my configuration. Interface eth 0ip address
> 20.20.20.20 255.255.255.0ip policy route-map aaa route-map aaa permit 10
> match ip address 2
> set ip precedence 2
> set ip next-hop 10.10.10.10 access-list 2 permit any Thanks
"debug ip policy" and then ping.
Is 10.10.10.10 reachable? Also try not to send email in HTML, as it really
screws up the formatting.
-- Jay Hennigan - CCIE #7880 - Network Administration - jay@west.net NetLojix Communications, Inc. - http://www.netlojix.com/ WestNet: Connecting you to the planet. 805 884-6323
This archive was generated by hypermail 2.1.4 : Thu May 01 2003 - 13:35:59 GMT-3