From: Songbin Wei (sbwei_2000@yahoo.com)
Date: Thu Mar 20 2003 - 20:28:02 GMT-3
ip rsvp bandwidth bw1 bw2
bw1 is the total bandwidth reservable on the
interface. bw2 is the bandwith reservable for one rsvp
session.
'req-qos controlled-load' dial-peer configuration
instructs the voip to set up a rsvp session when makes
call. If you want voip with rsvp, you need this
command. Remember that 'ip rsvp bandwidth' just makes
the router ready to set up rsvp, in order to rsvp,
some application must initiate the reservation.
'req-qos controlled-load' is one of the commands to
initiate the reservation.
For voip with default codec (g728), it will reserve
24kbps, so the config for one call is:
ip rsvp bandwidth 24 24
if you want to support 2 calls, configure:
ip rsvp bandwidth 48 24
For g711 codec, it will reserve 80kbps.
Try to test this using two phones. And 'show ip rsvp
installed' to check the rsvp sessions.
--- Hunt Lee <ciscoforme3@yahoo.com.au> wrote:
> Hi group,
>
> For RSVP, I found that if I just type "ip rsvp
> bandwidth" under an interface along
> the path that I wanted RSVP activated, it will
> automatically put in values for me...
> If I wanted to configure the values myself, how
> should I based this on? I have read
> a number of e.g. from books and CCO, and they mostly
> use
>
> interface s0
> ip rsvp bandwidth 48 48
>
> What does the 2 values mean?
>
> Also, I also saw this on a VoIP config:-
>
> dial-peer voice 2 voip
> destination-parttern 110
> session target ipv4:172.168.10.65
> req-qos controlled-load <---- Is this a
> mandatory command
> when using
> RSVP with voice? What does the
> command do?
>
>
>
> http://mobile.yahoo.com.au - Yahoo! Mobile
> - Check & compose your email via SMS on your Telstra
> or Vodafone mobile.
This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:42 GMT-3