RSVP

From: Hunt Lee (ciscoforme3@yahoo.com.au)
Date: Thu Mar 20 2003 - 10:48:33 GMT-3

• Next message: Ram Shummoogum: "Re: BGP neighbor"
• Previous message: Nawaz, Ajaz: "RE: serial gone bad"
• Next in thread: Songbin Wei: "Re: RSVP"
• Maybe reply: Songbin Wei: "Re: RSVP"
• Maybe reply: Phong Tran Tien: "RE: RSVP"
• Maybe reply: Hunt Lee: "RE: RSVP"
• Maybe reply: Phong Tran Tien: "RE: RSVP"
• Maybe reply: Cameron, John: "RE: RSVP"
• Maybe reply: Songbin Wei: "RE: RSVP"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi group,

For RSVP, I found that if I just type "ip rsvp bandwidth" under an interface along
the path that I wanted RSVP activated, it will automatically put in values for me...
If I wanted to configure the values myself, how should I based this on? I have read
a number of e.g. from books and CCO, and they mostly use

interface s0
 ip rsvp bandwidth 48 48

What does the 2 values mean?

Also, I also saw this on a VoIP config:-

dial-peer voice 2 voip
 destination-parttern 110
 session target ipv4:172.168.10.65
 req-qos controlled-load <---- Is this a mandatory command
                                         when using RSVP with voice? What does the
                                         command do?

http://mobile.yahoo.com.au - Yahoo! Mobile
- Check & compose your email via SMS on your Telstra or Vodafone mobile.

• Next message: Ram Shummoogum: "Re: BGP neighbor"
• Previous message: Nawaz, Ajaz: "RE: serial gone bad"
• Next in thread: Songbin Wei: "Re: RSVP"
• Maybe reply: Songbin Wei: "Re: RSVP"
• Maybe reply: Phong Tran Tien: "RE: RSVP"
• Maybe reply: Hunt Lee: "RE: RSVP"
• Maybe reply: Phong Tran Tien: "RE: RSVP"
• Maybe reply: Cameron, John: "RE: RSVP"
• Maybe reply: Songbin Wei: "RE: RSVP"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:42 GMT-3