RE: RSVP

From: Phong Tran Tien (PhongTT2@FPT.COM.VN)
Date: Fri Mar 21 2003 - 00:41:37 GMT-3

• Next message: Carlos: "Re: bgp command"
• Previous message: Brian Dennis: "RE: bgp command"
• Maybe in reply to: Hunt Lee: "RSVP"
• Next in thread: Hunt Lee: "RE: RSVP"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Also remembet to enable WFQ if you are using RSVP
 
#11285

        -----Original Message-----
        From: Songbin Wei [mailto:sbwei_2000@yahoo.com]
        Sent: Fri 3/21/2003 6:28 AM
        To: Hunt Lee; ccielab@groupstudy.com
        Cc:
        Subject: Re: RSVP
        
        

        ip rsvp bandwidth bw1 bw2
        bw1 is the total bandwidth reservable on the
        interface. bw2 is the bandwith reservable for one rsvp
        session.
        
        'req-qos controlled-load' dial-peer configuration
        instructs the voip to set up a rsvp session when makes
        call. If you want voip with rsvp, you need this
        command. Remember that 'ip rsvp bandwidth' just makes
        the router ready to set up rsvp, in order to rsvp,
        some application must initiate the reservation.
        'req-qos controlled-load' is one of the commands to
        initiate the reservation.
        
        For voip with default codec (g728), it will reserve
        24kbps, so the config for one call is:
        ip rsvp bandwidth 24 24
        if you want to support 2 calls, configure:
        ip rsvp bandwidth 48 24
        
        For g711 codec, it will reserve 80kbps.
        
        Try to test this using two phones. And 'show ip rsvp
        installed' to check the rsvp sessions.
        
        --- Hunt Lee <ciscoforme3@yahoo.com.au> wrote:
> Hi group,
>
> For RSVP, I found that if I just type "ip rsvp
> bandwidth" under an interface along
> the path that I wanted RSVP activated, it will
> automatically put in values for me...
> If I wanted to configure the values myself, how
> should I based this on? I have read
> a number of e.g. from books and CCO, and they mostly
> use
>
> interface s0
> ip rsvp bandwidth 48 48
>
> What does the 2 values mean?
>
> Also, I also saw this on a VoIP config:-
>
> dial-peer voice 2 voip
> destination-parttern 110
> session target ipv4:172.168.10.65
> req-qos controlled-load <---- Is this a
> mandatory command
> when using
> RSVP with voice? What does the
> command do?
>
>
>
> http://mobile.yahoo.com.au - Yahoo! Mobile
> - Check & compose your email via SMS on your Telstra
> or Vodafone mobile.

• Next message: Carlos: "Re: bgp command"
• Previous message: Brian Dennis: "RE: bgp command"
• Maybe in reply to: Hunt Lee: "RSVP"
• Next in thread: Hunt Lee: "RE: RSVP"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat Apr 05 2003 - 08:51:43 GMT-3