From: Brent Colwell (bcolwell@bellind.com)
Date: Thu Jan 16 2003 - 15:59:48 GMT-3
Barry, you have to put the command "cable-modem voip clock-internal" on the cable 0 interface to get dial-tone. This link explains why.
http://www.cisco.com/en/US/products/hw/cable/ps2221/products_qanda_item09186a008009441f.shtml#no_dial_tone
Brent
-----Original Message-----
From: Barry Rowland [mailto:reachbarry@bigfoot.com]
Sent: Thu 1/16/2003 1:00 PM
To: ccielab@groupstudy.com
Cc:
Subject: OT: UBR924 no dial tone.
Sorry for the OT, but I thought maybe someone else out there has run into
this.
I'm using 2 ubr924's, I picked up pretty cheap, to do Voip scenario's on my
home rack. The problem is
after using them for a day and everything worked fine, exept as noted below, I
come in the next morning and cannot get a dial tone for any of the ports on
either unit.
Debug indicates the ports do sense the off hook condition and come up with a
"tone", but you can't hear it on any of the phones. I have tried reboots, both
warm and power cycle, but still no dial tone. This is really strange, as the
same configs where working fine yesterday. I did have this problem with one of
the routers yesterday morning but after a few power cycles the ports came up!
I will be loading
a 12.2 Enterprise image this evening to see if this helps.
Thanks for any ideas!
Barry
.
.
This archive was generated by hypermail 2.1.4 : Sat Feb 01 2003 - 07:33:51 GMT-3