From: ccie candidate (ccie1@lycos.com)
Date: Sun Nov 03 2002 - 15:13:15 GMT-3
folks ;
i have 2501 router has an interesting problem
when the router boots , it do not accept any command from the hyper terminal ,however.
1-the boot process goes normally with all the messages shows on the hyper terminal .
2- i changed the DRAM , Flash , bootRom with working ones ,however the router still did not accept any command
3-when i send break signal , it breaks the boot process but again nothing shows up when i type any char .
4-the hyperterminal settings is working fine with other routers .
the only thing i might think of is the value of the config-reg , it might be something which dont allow receiving from the console ( just guessing )
so is there anything ( like jumper on the main board ) i can do to reset its value if this assumption is right .
otherwise what i miss here ????
regards
ccie
This archive was generated by hypermail 2.1.4 : Tue Dec 03 2002 - 07:22:51 GMT-3