From: kym blair (kymblair@hotmail.com)
Date: Sun Nov 10 2002 - 04:53:14 GMT-3
Same here. I have several 2500 routers and one does not work with
HyperTerminal (no matter what settings or which COM port). I switched to
CRT software and that router works fine, as do all the others.
Kym
>From: steve brown <stevelbrown@sympatico.ca>
>Reply-To: steve brown <stevelbrown@sympatico.ca>
>CC: ccielab@groupstudy.com
>Subject: Re: OT:2500 router problem
>Date: Sun, 10 Nov 2002 02:17:30 -0500
>
>Yes
>
>I had the exact same problem with a 2501, and it was the settings on
>hyperterminal. It's funny, because the settings I was using worked fine
>with my other routers (3x2514, 1x2515, 1x2525, 1x2625)
>but for some reason my 2501 got flaky.
>
>I use CRT and I've been happy with it.
>
>Steve
>
>Hansang Bae wrote:
>
> > At 10:13 AM 11/3/2002 -0800, ccie candidate wrote:
> > >folks ;
> > >i have 2501 router has an interesting problem
> > >when the router boots , it do not accept any command from the hyper
>terminal ,however.
> > >1-the boot process goes normally with all the messages shows on the
>hyper terminal .
> > >2- i changed the DRAM , Flash , bootRom with working ones ,however the
>router still did not accept any command
> > >3-when i send break signal , it breaks the boot process but again
>nothing shows up when i type any char .
> > >4-the hyperterminal settings is working fine with other routers .
> > >the only thing i might think of is the value of the config-reg , it
>might be something which dont allow receiving from the console ( just
>guessing )
> > >so is there anything ( like jumper on the main board ) i can do to
>reset its value if this assumption is right .
> > >otherwise what i miss here ????
> >
> > Could be that you have a damaged unit. But more likely, it's more
>finicky about flow control. Turn it off in HyperCrap. Or better yet, try
>using Tera Term so you can sleep well a night! <G>
> >
> > hsb
This archive was generated by hypermail 2.1.4 : Tue Dec 03 2002 - 07:22:56 GMT-3