From: Hansang Bae (hbae@nyc.rr.com)
Date: Sun Nov 10 2002 - 03:53:52 GMT-3
At 10:13 AM 11/3/2002 -0800, ccie candidate wrote:
>folks ;
>i have 2501 router has an interesting problem
>when the router boots , it do not accept any command from the hyper terminal ,however.
>1-the boot process goes normally with all the messages shows on the hyper terminal .
>2- i changed the DRAM , Flash , bootRom with working ones ,however the router still did not accept any command
>3-when i send break signal , it breaks the boot process but again nothing shows up when i type any char .
>4-the hyperterminal settings is working fine with other routers .
>the only thing i might think of is the value of the config-reg , it might be something which dont allow receiving from the console ( just guessing )
>so is there anything ( like jumper on the main board ) i can do to reset its value if this assumption is right .
>otherwise what i miss here ????
Could be that you have a damaged unit. But more likely, it's more finicky about flow control. Turn it off in HyperCrap. Or better yet, try using Tera Term so you can sleep well a night! <G>
hsb
This archive was generated by hypermail 2.1.4 : Tue Dec 03 2002 - 07:22:56 GMT-3