From: sanjeev (san_sri@xxxxxxxxxxxxx)
Date: Sat May 11 2002 - 23:36:11 GMT-3
Hello !
*I an connecting r1,r2,r3,r4 across a frame-relay cloud - r1 is the hub router
and is connected to r2,r3,r4 - each of these routers has a frame-relay config w
ith physical interfaces- r2,r3 ,r4 has a physical map statement
i need to enable on the frame-relay hub router main serial "no ip split-horizon
..." for this eigrp config.
1> r2 has two other interfaces with ip address 192.168.88.2/25 and 192.168.88.2
06/25 and these are included in the eigrp definitions in r2; do we need to d
o anything special for these 2 ip addresses to
appear in the eigrp table of r1,r3 and r4?
2> when do i use the neighbour statements under eigrp at the spoke routers r2,r
3,r4 and when do we use neighbour statements at r1 ? do all the other routers
have to be defined as a neighbour ?
3>for igrp what are the rules for split-horizon rules applicable ? i need to en
able on the frame-relay hub router main serial "no ip split-horizon..." for thi
s eigrp config?
many thanks !
------------------------------------------------------------------------
cOntact @ Lycos <http://contact.lycosasia.com>
= 20MB for email and filestore + lots of other goodies...
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:55 GMT-3