From: Jason Sinclair (sinclairj@xxxxxxxxxxxxxxx)
Date: Thu Apr 18 2002 - 23:48:43 GMT-3
Babacar,
I see two issues if these routers are connected to the same MAU. You have
the same address configured on both interfaces. The other issue is that the
same ring number must be used across a local MAU as there is no bridge in
the middle.
Regards.
Jason Sinclair CCIE #9100
Manager, Network Support Group
POWERTEL
Ground Level, 55 Clarence Street,
SYDNEY NSW 2000
AUSTRALIA
office: + 61 2 8264 3820
mobile: + 61 416 105 858
* sinclairj@powertel.com.au
-----Original Message-----
From: Babacar Diop [mailto:babacard2000@yahoo.com]
Sent: Friday, 19 April 2002 12:00
To: ccielab@groupstudy.com
Subject: DLSw question.
I have configured DLSw on two routers:
R5
Source-bridge ring-group 100
interface TokenRing0
ip address 133.14.33.1 255.255.255.0
ring-speed 16
source-bridge 10 1 100
R3
Source-bridge ring-group 100
interface TokenRing0
ip address 133.14.33.1 255.255.255.0
ring-speed 16
But everytime i applied "source-bridge 20 1 100" to
R3's T0 i get the follwing message on the console:
00:37:50: %TR-3-BADRNGNUM: Unit 0, ring number (20)
doesn't match established number (10).
00:37:50: %LANMGR-4-BADRNGNUM: Ring number mismatch on
TokenRing0, shutting down the interface
00:37:52: %LINK-5-CHANGED: Interface TokenRing0,
changed state to administratively down
Am i supposed to configure different virtual ring
numbers?
Thanks
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:12 GMT-3