From: Mohamed I. Lubbad (mlubbad@xxxxxxxxxxx)
Date: Sat Mar 23 2002 - 14:57:40 GMT-3
Try and configure different VPI/VCI numbers on both sides of the switch.
interface atm 1/0/1
atm pvc 0 426 interface atm 1/0/0 0 624
Do a "show atm map" and try to debug to see if packets are leaving the ATM
port or not.
On the LS1010, do a " show atm vc" to make sure if the PVC you created is
between the correct ATM ports on the switch and if it is UP or not.
Mohamed I. Lubbad
----- Original Message -----
From: "Ahmed Mamoor Amimi" <mamoor@ieee.org>
To: <ccielab@groupstudy.com>
Sent: Saturday, March 23, 2002 20:18
Subject: please help me out
> Dear folks.
>
> Its my first time on ATM so please help me out in this.... I wanted to
> configure the some scenario for ATM by using the new commands but didn't
work
> out then i tried the old one and here is the configuration. let me know if
i
> did some thing wrong
>
> R4------Ls1010--------R6
>
>
> Switch
>
> interface ATM1/0/0
> no ip address
> no ip directed-broadcast
> logging event subif-link-status
> atm ilmi-keepalive
> !
> interface ATM1/0/1
> no ip address
> no ip directed-broadcast
> logging event subif-link-status
> atm ilmi-keepalive
> atm pvc 0 100 interface ATM1/0/0 0 100
> !
>
>
> R4
>
> interface ATM0
> ip address 192.168.1.1 255.255.255.0
> map-group baleegh
> atm pvc 1 0 100 aal5snap
> no atm ilmi-keepalive
> !
> ip classless
> no ip http server
> !
> !
> map-list baleegh
> ip 192.168.1.2 atm-vc 1 broadcast
>
> R6
>
> interface ATM0/0
> ip address 192.168.1.2 255.255.255.0
> map-group baleegh
> atm pvc 1 0 100 aal5snap
> no atm ilmi-keepalive
> !
> interface Ethernet2/0
> no ip address
> shutdown
> half-duplex
> !
> ip classless
> ip http server
> !
> !
> map-list baleegh
> ip 192.168.1.1 atm-vc 1 broadcast
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:57:19 GMT-3