From: John Neiberger (neiby@xxxxxxxxxx)
Date: Sat Nov 24 2001 - 02:43:11 GMT-3
I'm having trouble configuring this and it seem that there ought to be a way
to do this. Here is the scenario:
R1----(t/r)-----R2---(serial)---R3 ----(eth)---- R4
IP routing is turned off on R2 and R3. I'm attempting to transparently
bridge IP from the t/r segment to the ethernet segment and I'm failing
miserably.
I've tried a few different things with no success. At the moment I'm
playing with SR/TLB on R2, but usually that involves T/R to Eth conversion
on the same router, right? In this case it's T/R to serial and this isn't
working so far.
If I wasn't trying to bridge IP I could use DLSw, but I don't see how I
could use that here.
I should mention that this isn't part of a lab scenario, I just wanted to
see if I could do it.
Any thoughts? I think I'm going to give up for the evening and try again
tomorrow when I can actually think clearly. <g>
Thanks,
John
This archive was generated by hypermail 2.1.4 : Fri Jun 21 2002 - 06:45:22 GMT-3