From: perkinsr@xxxxxxxxxxxxxx
Date: Mon Oct 15 2001 - 14:21:01 GMT-3
I cannot get IRB to work. Here is the IRB scenario from lab 8, the only
differance is there is token instead of ether between R1 and R7.
BVI1
|
-----R5----------------------R1----------------------R7--t5/3
s0 s1 to0 t5/0
This is tough, I can't ipx ping from R7 to R5, but routing info is passed.
R7 all routes beyond R5, R7 is a stub, but net 701 (off t5/3) is visible
from R5. Pings will not work though. I was thinking frame type
concic/non-concical type problems. I tried making the MAC of t5/3 0.0.ff so
that it would be the same either way, but that didn't work. The BVI1 on R5
is set to SAP frame type just like the token interface on R7.
Help....
configs:
R5
ipx routing 0000.0000.0005
!
interface Serial1
ip address 137.20.25.1 255.255.255.0
no ip directed-broadcast
ip accounting output-packets
no logging event subif-link-status
bridge-group 1
!
interface BVI1
no ip address
no logging event subif-link-status
ipx encapsulation SAP
ipx network 700
!
ipx router eigrp 10
network 5130
network 5004
network 695
!
!
ipx router rip
no network 5130
no network 5004
no network 695
!
bridge irb
bridge 1 protocol ieee
bridge 1 route ip
bridge 1 route ipx
no bridge 1 bridge ip
R1
!
interface Serial0
ip address 137.20.25.2 255.255.255.0
no ip route-cache
no ip mroute-cache
clockrate 64000
bridge-group 1
!
interface TokenRing0
ip address 137.20.10.1 255.255.255.0
no ip route-cache
no ip mroute-cache
ring-speed 16
bridge-group 1
!
bridge 1 protocol ieee
R7
ipx routing 0000.0000.0007
!
interface TokenRing5/0
ip address 5.5.5.5 255.255.255.0 secondary
ip address 137.20.10.70 255.255.255.0
ipx network 700
ring-speed 16
!
interface TokenRing5/3
ip address 172.168.70.1 255.255.255.0
ipx network 701
ring-speed 16
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 22:33:19 GMT-3