From: Nicholas Jaksec (jaksec@xxxxxxxxxx)
Date: Sun Sep 02 2001 - 20:30:52 GMT-3
Can the "IP Precedence" command determine which Dial Peer statement has
higher priority to call the same phone #, example:
"R1" has two IP subnets in its routing table (10.1.1.0 & 11.1.1.0) to reach
the same Phone # "3002" on "R2" but I only want traffic to use the one
subnet (10.1.1.2) at all times. Can IP Precedence do this by making the
values different, if so which value (5 or 6) has the higher priority. I am
not sure if higher values have the higher priority or the lower values.
"R1"
dial-peer voice 1 voip
destination-pattern 3002
session target ipv4:10.1.1.2
ip precedence 5
!
dial-peer voice 2 voip
destination-pattern 3002
session target ipv4:11.1.1.2
ip precedence 6
"R2"
dial-peer voice 1 pots
destination-pattern 3002
port 1/0/0
********************************************
Nicholas R. Jaksec, CCNP, CCDP, MCSE+I, CNA
Network Systems Engineer
Lucent Worldwide Services
One North Shore Center
12 Federal St. Suite 420
Pittsburgh, Pa 15212
Office: 412-330-6336 Fax: 412-323-7665
Pager: 1-800-467-1467
Email: jaksec@lucent.com
********************************************
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:13 GMT-3