From: Menga, Justin (Justin.Menga@xxxxxxxxxx)
Date: Mon Sep 03 2001 - 00:38:23 GMT-3
Use preference command (not ip precedence) - default is 0 and lowest is always
preferred. So your config should be:
dial-peer voice 1 voip
destination-pattern 3002
session target ipv4:10.1.1.2
ip precedence 5
preference 0 (this won't actually show in the config as it is the default)
!
dial-peer voice 2 voip
destination-pattern 3002
session target ipv4:11.1.1.2
ip precedence 5
preference 1
Regards
Justin Menga CCIE #6640
Network Solutions Architect
Wireless & E-Infrastructure
Compaq Computer New Zealand
DDI: +64-9-918-9381 Mobile: +64-21-349-599
mailto: justin.menga@compaq.com
web: http://www.compaq.co.nz
-----Original Message-----
From: Nicholas Jaksec [mailto:jaksec@lucent.com]
Sent: Monday, 3 September 2001 11:31 a.m.
To: CCIE
Subject: VOI P Question
Can the "IP Precedence" command determine which Dial Peer statement has higher
priority to call the same phone #, example:
"R1" has two IP subnets in its routing table (10.1.1.0 & 11.1.1.0) to reach the
same Phone # "3002" on "R2" but I only want traffic to use the one subnet (10.
1.1.2) at all times. Can IP Precedence do this by making the values different,
if so which value (5 or 6) has the higher priority. I am not sure if higher val
ues have the higher priority or the lower values.
"R1"
dial-peer voice 1 voip
destination-pattern 3002
session target ipv4:10.1.1.2
ip precedence 5
!
dial-peer voice 2 voip
destination-pattern 3002
session target ipv4:11.1.1.2
ip precedence 6
"R2"
dial-peer voice 1 pots
destination-pattern 3002
port 1/0/0
********************************************
Nicholas R. Jaksec, CCNP, CCDP, MCSE+I, CNA
Network Systems Engineer
Lucent Worldwide Services
One North Shore Center
12 Federal St. Suite 420
Pittsburgh, Pa 15212
Office: 412-330-6336 Fax: 412-323-7665
Pager: 1-800-467-1467
Email: jaksec@lucent.com
********************************************
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:13 GMT-3