From: sanjay (ccienxtyear@xxxxxxxxxxx)
Date: Thu Aug 09 2001 - 18:26:45 GMT-3
How to configure Transparent bridging between a ethernet interface and
loopback interface on the same router. I know the commands are something like
this:
bridge 1 protocol ieee (at the global config level)
and then assign the bridge group to the interface. I can put the "bridge-group
1" command under ethernet, but loopback interface doesn't accept the
bridge-group 1 command. The message is "loopback doesn't support bridging"
Any ideas ?
thanks,
Sanjay
**Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:31:48 GMT-3